BZ Heels??????? What are they?

[Julie88]

Just let me know where and when

[love_prada_and_gucci]

Awesome heels I could imagine the result

[Ginas1120]

Hi Julie,
My X-boyfriend had a couple of pairs of my heels outfitted with those metal hollowed out heels. I LOVED to walk on him on his back and chest and watch the marks they left. They are viscious spike heels meant to do damage and leave permanent marks....

I love to tattoo guys with them:)

Gina

[Spikey983]

Hey, Julie
Hows about some pics of your feet, legs and ankles wearing a pair, or two, of BZ's?

[Julie88]

Hi Spikey,
Would that get you off? Do you whack off to my pictures now?

Julie

[Spikey983]

Hi, Julie,
You never know, it just might! It's been a while

[tripleaheels]

Wow Gina and Julie speak oddly similar....

[Wetshoe]

At Fetishcon perhaps?

[nailheels12]

Is there anyone still making BZ's I'd love to get some of my girls into them for the site? I've always thought that a well exposed heel nail would be the most damaging thing, but a variation might be cool

[sinkem]

Making BZHeels is not all that hard (for what it's worth, the 'BZ' is the first and middle initials of the person who created these heels originally):

First you need to get a hold of an appropriately sized hex screw (it is a screw that has a hex head on top rather than a slot for a screw driver).
Then take one of the heel tips out of the shoe to be modified, including the pin that holds it on the heel. Put the hex screw into a drill, with the threaded shaft sticking out. Using a metal file, file the threaded shaft to just slightly larger than the original pin diameter.
Now put the hex screw into a vise, with the shaft that had the threads in the vice and the hex head protruding up. Take a drill be that is about 0.125 inches smaller than the outside diameter of the hex head. Using this drill bit, drill out the center of the hex head, only about 75% of depth of the height of the hex head.
Insert the hex screw shaft into the heel that the original tip was removed. It should be relatively tight. Too loose and the tip will come out too easily.
You may need to do some trial fitting until that shaft is sufficiently tight that it is not too loose and so tight that it deforms the metal tube in the heel. You may also want to cement the heel tip in, but this will make it difficult to replace in the future.

Repeat the above for the other heel.

Done.